Loading ...
Loading ...
Loading ...
360
Wheels and tyres
1
2
3
4
5
6
7
8
9
10
11
Anti-puncture kit contents
Fig.245 St
andard display: contents of the
anti-puncture kit.
The anti-puncture kit is located underneath the
floor co
vering in the luggage compartment. In-
cludes the following components ›››Fig.245:
Valve insert remover
A sticker to be adhered to the instrument
cluster, within the driver's visual field, to re-
mind that the maximum advisable speed
“max. 80 km/h” or “max. 50 mph”
Filler tube with cap
Air compressor (depending on the version,
the model may vary).
ON/OFF switch
Air bleed screw (it can also be integrated in
the inflator tube).
Warning provided by tyre pressure monitor-
ing syst
em (it can also be integrated in the
inflator tube).
Tube for inflating tyres
12 volt connector
Bottle of sealant
Spare tyre valve
The valve insert remover
1
has a gap at the
l
ower end for a valve insert. The valve insert can
only be screwed or unscrewed in this way. This
also applies to its replacement part
11
.
Sealing and inflating a t
yre
Sealing the tyre
●
Unscrew the tyre valve cap and insert. Use
the device ›››Fig.245
1
to remove the valve
cap
. Place it on a clean surface.
●
Shake the tyre sealant bottle vigorously
›››Fig.245
10
.
●
Screw the tyre inflation hose ›››Fig.2
45
3
into the tyre sealant bottle. The bottle's seal will
br
eak automatically.
●
Remove the filler cap ›››Fig.245
3
and
scr
ew the open end of the tube into the tyre
valve.
●
With the bottle upside down, empty all of the
cont
ents into the tyre.
●
Remove the bottle from the valve.
●
Replace the howitzer with the device
›››Fig.2
45
1
onto the tyre valve.
Inflating the t
yre
●
Screw the tyre inflation tube of the compres-
sor ›››Fig.245
8
on the tyre valve.
●
Check that the air evacuation screw is
cl
osed ›››Fig.245
6
.
●
Start the engine and leave it running.
●
Attach the connector ›››Fig.2
45
9
to the
v
ehicle’s 12 volt power outlet ›››page231.
●
Switch on the air compressor with ON/OFF
switch ›››Fig.245
5
.
●
Keep the air compressor running until it rea-
ches a pr
essure of 2.0-2.5 bar (29-36psi/
200-250 kPa). A maximum of 8 minutes.
●
Disconnect the air compressor.
●
If it does not reach the pressure indicated,
unscrew the tyre inflator tube from the valve.
●
Move the vehicle 10m so that the sealant is
distributed throughout the tyre.
●
Screw the compressor tyre inflator into the
valve.
●
Repeat the inflation process.
●
If it still does not come up to pressure, the
tyre is too badly damaged. Stop and seek as-
sistance from authorised personnel.
●
Disconnect the air compressor. Unscrew the
t
yre inflation tube from the tyre valve.
Loading ...
Loading ...
Loading ...