Loading ...
Loading ...
Loading ...
Driver information
25
Instrument panel
Odometer
The od
ometer registers the total distance trav-
elled by the car.
The partial odometer (trip) shows the dis-
tance travelled since the last time it was reset
to zero.
●
Set the odometer to zero via the Infotainment
syst
em or the multifunction steering wheel
›››page25.
To reset the trip odometer ( trip ) to 0:
●
When in T
ravel data select trip.
●
Hold the
button on the wiper lever
or the button on the multifunction steering
wheel do
wn for about 2 seconds.
Combined operating range display
(hy-
brid v
ehicles)
The value shown is calculated and updated ac-
cording to the driving style. Therefore, the range
can vary even when the fuel tank is full and the
high-voltage battery is fully charged.
Range can be increased by reducing or switch-
ing o comfort consumers, e.g. air conditioning
or seat heating.
Speed warning for winter tyres
If the maximum set speed is exceeded, this is
displayed on the instrument cluster display.
The speed warning can be set in the infotain-
ment system ›››page40.
Compass indication
Depending on the equipment, when the ignition
is on, the instrument panel display indicates the
direction in which you are driving with a symbol,
e.g. NW for Northwest.
When the Infotainment system is on and there is
no route guidance active, the graphic represen-
tation of a compass is also shown.
Low consumption driving
Depending on the equipment, when driving, the
display appears on the instrument panel
when the v
ehicle is in low consumption status
due to active cylinder management (ACT®)
›››page147.
WARNING
Even when the outside temperature is higher
than fr
eezing temperature, some roads and
bridges could be frozen.
●
The “ice crystal symbol” indicates that
there may be a risk of freezing.
●
At outside temperatures above +4°C
(+39°F), there may be ice even when the “ice
crystal symbol” is not on.
●
The outside temperature sensor takes a
guideline measurement.
Note
●
There are dier
ent instrument panels and
therefore the versions and instructions on
the display may vary. In the case of dis-
plays without warning or information texts,
faults are indicated exclusively by the con-
trol warning lamps.
●
Some indications on the instrument panel
scr
een may be concealed by a sudden
event, e.g. an incoming call.
●
Depending on the equipment, some set-
tings and instructions can be carried out
or displayed on the infotainment system as
well.
●
If there are several warnings at the same
time, the symbols will be displayed one after
the other for a few seconds. The symbols will
stay on until you remove the cause.
●
If when switching on the ignition warnings
are shown about existing faults, it might not
be possible to change the settings or show
the information as described. In this case, go
to a specialised workshop and request a re-
pair.
Driving data indicator
The driving data display shows a range of driv-
ing data and consumption values.
Change from one display to another
●
Turn the right thumbwheel of the multifunc-
tion st
eering wheel ›››page35.
Loading ...
Loading ...
Loading ...