Loading ...
Loading ...
Loading ...
En
25
Changing the settings
Changing the velocity curve setting of velocity
sampler mode
Set the velocity curve of the velocity sampler mode. The velocity curve can be
selected from four types.
! By default, curve 3 is set.
Press the [AUTO BEAT LOOP] button on the deck whose
setting you want to set.
The velocity curve setting changes each time the [AUTO BEAT LOOP] button is
pressed.
The currently set value is indicated by how the [LOOP 1/2X], [LOOP 2X], [LOOP IN]
and [LOOP OUT] buttons light.
Curve 1
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Curve 2
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Curve 3
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Curve 4
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Adjusting the jog dial’s MIDI message sending
interval
This unit is equipped with a mode for adjusting the jog dial’s MIDI message sending
interval.
Depending on your computer’s operating system and specifications, the jog dial
may not operate properly if the sending interval of MIDI message for JOG dial is too
short. In this case, follow the procedure below to adjust the MIDI message sending
interval.
! From a short MIDI sending interval, increase the interval to a length at which no
problems occur.
! The default is 1 ms.
Press the [SHIFT] button on the left deck.
The MIDI message sending interval setting changes each time the button is
pressed. The currently set value is indicated by how the master level indicator is lit.
Disabling the auto standby function
! When auto standby function is set to on, if 4 hours have passed while the follow-
ing conditions are all met, the unit automatically enters standby status.
— Buttons and controls of the unit except the [MIC1] control and [MIC2] control
are not operated.
— That no audio signals of -18 dB or greater are input to this unit’s input terminals.
! When the [PANEL (WAKE UP)] button is pressed, the standby mode is canceled.
! By default, the auto standby function is enabled.
Press the [GRID ADJUST] button of the left side deck.
! [GRID ADJUST] button lit: Auto standby function is enabled
! [GRID ADJUST] button off: Auto standby function is disabled
Changing the talk over function setting
About talk over mode
The talk over function has the two modes described below.
Advanced talk over mode: Sound other than the microphone channel is output with
only the midrange attenuated per the talk over level setting.
dB
Frequency
Normal talk over mode: Sound other than the microphone channel is output attenu-
ated per the talk over level setting.
dB
Frequency
! By default, the advanced talk over mode is set.
Press the [GRID SLIDE] button of the left side deck.
! [GRID SLIDE] button lit: Advanced talk over mode
! [GRID SLIDE] button off: Normal talk over mode
Loading ...
Loading ...
Loading ...