Loading ...
Loading ...
Loading ...
12
– Use protective gloves.
– Ensure that the oven is cold before carrying out the following
operations.
– Disconnect the appliance from the mains power supply.
WARNING
REMOVING THE DOOR
To remove the door:
1. Open the door fully.
2. Lift the catches and push them forwards as far as they will go (g. 1).
3. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is
released (D) (g. 2).
To ret the door:
1. Insert the hinges in their seats.
2. Open the door fully.
3. Lower the two catches.
4. Close the door.
REMOVING THE SIDE GRILLES
The side accessory-holder grilles are equipped with two xing screws
(g.3) for optimum stability.
1. Remove the screws and relative plates on the right and left with
the aid of a coin or tool (g.4).
2. To remove the grilles, lift them up (1) and turn them (2) as shown
in g.5.
REPLACING THE LAMP
To replace the rear lamp (if present):
1. Disconnect the oven from the mains power supply.
2. Unscrew the lamp cover, replace the lamp (see note for lamp type)
and screw the lamp cover back on.
3. Reconnect the oven to the power supply.
N.B:
– Use only 25-40W/230V type E-14, T300°C incandescent lamps, or
20-40W/230 V type G9, T300°C halogen lamps.
– The lamp used in the appliance is specically designed for
electrical appliances, and is not suitable for household room
illumination (Commission Regulation (ES) no. 244/2009).
– Lamps are available from our After-Sales Service.
IMPORTANT:
– If using halogen lamps, do not handle with bare hands since
ngerprints can damage them.
– Do not use the oven until the lamp cover has been put back in
place.
(Fig.3)
(Fig.4)
(Fig.5)
Fig. 1
Fig. 2
Maintenance
Loading ...
Loading ...
Loading ...