Loading ...
Loading ...
Loading ...
Changing Needle
O Needle clamp screw
(_ Needle clamp
[]Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering
the presser foot° Loosen the needle clamp screw(_ by
turning it counterclockwise_ Remove the needle from the
needle clamp (_
[] Insert a new needle into the needle clamp (_ with the
flat side to the rearmWhen inserting the needle into the
needle clamp(_), push it up as far as it goesoTighten
the needle clamp screw O firmly by turning it clockwise.
[_To check for a good needle, place the flat side of the
needle onto something flat (needle plate, glass, etc.).,
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle,,
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
To Remove and Attach the Foot Holder
O Thumb screw
(_ Foot holder
(_ Presser bar
• To remove
Remove the thumb screwOby turning it counterclock
wise with a screwdriver.
. To attach
Match the hole in the foot holder(_)with the threaded
hole in the presser bar (_)o Fit the thumb screw(_)into
the hole. Tighten the screw Oby turning it clockwise with
screwdriver.
Changing Presser Foot
(_ Snap-on button (red button)
(_) Groove
OPin
• To remove
Raise the needle to its highest position by turning the
handwheel counterclockwise° Raise the presser foot, and
press the red button (_ on the back of the foot holder.
• To attach
Place a selected presser foot so the pin(_)on the foot lies
just under the groove(_on the foot holder° Lower the
presser bar to lock the foot in place°
f-
[]
7
/
_:r_oSipdl:nO Needle 1
M_plat vers Aguja !
• Aiguille _j
[]
t/l! _
\
f
!.
J
J
10
Loading ...
Loading ...
Loading ...