Loading ...
Loading ...
Loading ...
I'.'lol#l_la,_'tMoloJIIA_I
Problem
No sound from the rear
center speaken
A "humming" sound can
be heard.
The volume level cannot
be increased, or the
sound is distorted.
Cause
"SOUND IC REAR LR" or "SOUND 1D
REAR C_!'' on the set menu is set to NON.
The Dolby Digital EX or ihe DTS-ES
decoder is not switched on.
Incorrect cable conllectJons.
The component connoted to the OUT
(REC) jacks of this unit is turned off2
Remedy
Select LRG or SML.
Press 6.1/5.1 on the remote control to switch the
decoder on.
Firmly conn_i lhe audio plugs. If the problem
persists, the cables may be defective.
Tunl oll lhe power to the component.
Refer
page
4O
The sound effect cannot It is not possible to record the sound effect
be recorded, with a recording componenL _
There is no source component conilec[ed Conilec[ tile sotlrce compenent [o the DIGITAL I 0 - 12
A source cannot be to the DIGITAL INPUT jacks of this unit. INPUT jacks of this unit.
recorded by a digital
recording component
connected to the
DIGITAL OUTPUT jack of
this unit.
The sound field "OPTION 2 MEM. GUARD" in the set Set "OPTION 2 MEM. GUARD" in tile set menu
_arsmeters and some menu is set to ON. to OFF.
other settings on the
unit cannot be changed.
The unit does not The internal rnicl_computer has been Disconnect the AC power cord from the out]e_
operate properly, frozen by an extenlal electric shock (such and then plug it in again after abou_ 30 seconds.
as lightning or excessive static electricity)
or by a power supply with low voltage.
"CHECK SP WIRES" Tile speaker cables are short circuited. Make sure all speaker cables are connected
appears on the front correctly.
panel display.
There is noise interfer- This unit is too close to tile digital or high- Move this unit further away from such
ence from digital or frequency equipment, equipment.
high-frequency
equipment, or this unit.
The unit suddenly turns The internal temperature has become too Wait tmli] tile unit cools down and then turn it
into standby mode. high and _he overheat protection circuitry back on.
has been activated.
|
53
Loading ...
Loading ...
Loading ...