Loading ...
Loading ...
Loading ...
• Connections
Be sure to connect 1he lefl channel (L), right channel (R), "+" (red) and "-" (black) in accordance with the markers on
this unit, the speakers, and the speaker cables. If the connections are faulty, no sound will be heard from the speakers,
and if the polarity of 1he speaker connections is incorrect, the sound will be unnatural and lack bass.
[_J#JiNffeJ/I
• Use speakers wilh the specified impedance shown on the rear panel of 1his unit,
• Do not let the bare speaker wires touch each other or any metal pail of this unit. This could damage 1his unit and]
or the speakers.
Red: positive (+) ,"
Black: negative (-) _
Banana plug
(With the exception of U.K. and Europe models)
A speaker cord is actually a pair of insulaled cables
running side by side. One cable is colored or shaped
differently, perhaps with a slripe, groove or ridge.
[] Remove approximately 10 mm (3/8") of
insulation from each of the speaker cables.
[] Twist the exposed wires of the cable
together to prevent short circuits.
[] Unscrew the knob.
[] Insert one bare wire into the hole in the side
of each terminal.
[] Tighten the knob to secure the wire.
(With the exception of U.K. and Europe models)
• You can also use banana plug connectors. First, tighten the
knob and then insert the banana plug connector into the end of
the corresponding terminal.
• IMPEDANCE SELECTOR switch
WARNING
Do not change setting of 1he IMPEDANCE SELECTOR swilch when 1he unit power is switched on, as doing so may
damage the unit. If fhis unit fails m turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the
IMPEDANCE SELECTOR swilch may not be fully slid to either position. If this is lhe case, slide the swilch all the
way to either position when this unit is in standby mode. Be sure to move this switch only when this unit is in
standby mode.
Select the swilch position (left or right) according to the impedance of 1he speakers in your system.
(General model) Impedance level
If you use one/two set(s) of main speakers, the impedance of
each speaker must be 4 _/8 _ or higher.
IMPEDANCE SELECTOR
switch
Swilch Speaker
position
Main
Left
Cenler,
Rear Cenler,
Rear
Main*
Right
Cenler,
Rear Cenler,
Rear
The impedance of each speaker must be 6 _ or higher.
If you use one/two set(s) of main speakers, the impedance of
each speaker must be 8 _/16 _ or higher.
The impedance of each speaker must be 8 _ or higher.
* [Canada model only]
When the switch is set to right, you cannot use "A+B'.
16
Loading ...
Loading ...
Loading ...