Loading ...
Loading ...
Loading ...
Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed
below or if the instruction below does not help, set this unit to standby mode, disconnect the power cord, and contact the
nearest authorized YAMAHA dealer or service center.
• General
Problem Cause Remedy Refer to
page
This unit fails to turn q'he power cord is not connoted or the Connect the power cord firmly.
on when STANDBY/ plug is not completely inserted.
ON (or SYSTEM
POWER) iS pressed, The IMPEDANCE SELECTOR switch on Set the switch fully to tile left or right position when 16
or enters in standby the t_ar panel is not tully sel Io either the this unit is in standby mode.
mode soon after the left or right position.
_ower has been
turned on. The protection circuitry has been Make sure all speaker wire connections on this unit 16 - 17
activated, and oil all speakers are secm_ and that the wire for
each connection is not touching anything olher than
its respective connection.
This unit has been exposed Io a strong Set this unit in standby mode, disconnect the power
external el_tric shock (such as lightning cord, plug it back in after 30 seconds, then use it
and strong static electricity), nolxnally.
NO Sound. Incorrect input or output cable connec- Connect the cables properly. If the problem persists, I 0 - 17
tions, the cables may be defective.
No appropriale input somme is selected. Select an appropriate input source with INPUT or 22
6CIt INPUT (or the input selector buttons).
The speaker connections are iio[ secure. Secure the conilections. [ 6 - 17
Tile main speakers have not been selected Select the main speakers with SPEAKERS A and/or 22
properly. B.
Tile volume is turned down. Turn up the volume. 23
The sound is muted. Press MUTE or any operation buttons on the unit to
cancel mute and adjust the volume.
Digital signals which this unit cannot Play a soume whose signals this unit can reproduce.
reproduce are being l_ceived from a
source compenent e.g; a CD-ROM.
The picture does not The output and input t_r the picture are I t) - l 1
appear, connected to dif!_rent types of video
jacks.
16The sound suddenly
goes off.
Tile protection circuit has been activated
because of a short circuit, etc.
The sleep timer has turned the unit off[
The sound is muted.
Connect components using tile same type of video
jacks (S VIDEO, VIDEO (composite), or COMPO-
NENT VIDEO) for both the input and output.
Check tbe IMPEDANCE SELECTOR switch is set to
the appropriale position and then turn the unit back
on.
Check the speaker wires are not touching each other
and then turn lhe unit back on.
Turn on the power, and play tile source again.
Press MUTE or any operation buttons on the unit to
cancel a mute and adjust the volume.
|
51
Loading ...
Loading ...
Loading ...