Loading ...
Loading ...
Loading ...
264
Miscellaneous situations
●
Do not touch the glass part of the bulb
with your bar
e hands, use a cloth or paper
towel instead, since the fingerprints left on
the glass will vaporise as a result of the heat
generated by the bulb, they will be deposited
on the reflector and will impair its surface.
●
Depending on the level of equipment fitted
in the vehicle, LEDs may be used for part
or all of the interior and/or exterior lighting.
LEDs have an estimated life that exceeds
than that of the car. If an LED light fails, go to
an authorised workshop for its replacement.
Changing bulbs
Tail light bulbs located in the bodywork
Fig.170 Boot: access t
o the bolt securing the
tail light unit.
Fig.171 R
etaining tabs on reverse side of tail
light.
Follow the steps indicated:
●
Check which of the bulbs is defective.
●
Open the rear lid.
●
Remove the lid, levering the flat side of a
scr
ewdriver into the recess ›››Fig.170
1
.
●
Remove the bulb connector
2
.
●
Unscrew the bolt securing the light
3
by
hand or using a scr
ewdriver.
●
Remove the light from the body, gently pull-
ing it toward you, and place on a clean, smooth
surface.
●
Remove the bulb holder unlocking the retain-
ing tabs ›››Fig.171
A
.
●
Change the damaged bulb.
●
To r
efit follow the steps in reverse order, taking
special care when fitting the bulb holder. The
securing tabs must click into place.
NOTICE
Take care when removing the rear light unit
t
o make sure there is no damage to the paint-
work or any of its components.
Note
●
Make sure you have a soft cloth ready to
pl
ace under the glass on the rear light unit, to
avoid any scratches.
●
For LED lights, you can only change the
turn signal and reverse light bulbs.
Tail lights bulbs located in the rear lid
Fig.172 R
ear lid open: remove the lid.
Loading ...
Loading ...
Loading ...