Loading ...
Loading ...
Loading ...
126
Driving
the fault corrected by a specialised workshop
without del
ay. If they do not turn o, do not
continue driving. Seek specialist assistance.
Faults in the gearbox
Gearbox: Fault! Stop the vehi-
cle and place the lever in the P
●
There is a fault in the gearbox. Stop the vehi-
cl
e in a safe place and do not continue driving.
Seek specialist assistance.
Gearbox: System fault! You may
continue driving
●
Have the fault corrected by a specialised
w
orkshop without delay.
Gearbox: System fault! You can
continue driving with restrictions.
Reverse gear disabled
●
Take the vehicle to a specialised workshop
and hav
e the fault repaired.
Gearbox: System fault! You can
continue driving in D until switch-
ing off the engine
●
Park the vehicle in a safe place. Seek special-
ist assist
ance.
Gearbox: too hot. Adapt your
driving accordingly
●
Continue driving at moderate speeds. When
the w
arning lamp switches o, you can con-
tinue driving in a normal manner.
Gearbox: press the brake and
engage a gear again
●
If the warning was caused by the temperature
of the gearbo
x, this driver message will be dis-
played when the gearbox has cooled again.
Back-up programme
If all the gear positions are shown over a light
background on the instrument cluster, there is
a system fault and the automatic gearbox will
operate with the backup programme. It is still
possible to drive the vehicle, however, at low
speeds and within a selected range of gears.
Driving in reverse gear may not be possible.
Manual release of the selector lever
Fig.90 Selector lever: manual release from
position P.
In the event of a power failure when starting
(e
.g. discharged battery), the lever will remain
locked in position P. To move it to position N
to move the vehicle, there is an emergency re-
l
ease device under the centre console, on the
right side. Releasing the selector lever requires
a certain degree of practical skill.
Removing the cover from the selector lever:
●
Connect the electronic parking brake ›››
.
●
Carefully pull the corners of the selector lever
boot and twist it up
wards over the lever handle.
Releasing the selector lever:
●
Using the flat part of a screwdriver, press the
yellow tab sideways and keep it pressed down
›››Fig.90.
●
Press the lock button on the selector
lever and move it to positionN.
●
After completing the emergency release, re-
attach the selector lever boot to the gearbox
console.
WARNING
Do not move the lever from position P if the
parking br
ake is not firmly engaged. If you
still think the car could move, press the brake
pedal. Danger! The vehicle could move in an
unforeseen way and cause an accident or
serious injury.
Loading ...
Loading ...
Loading ...