Loading ...
Loading ...
Loading ...
Requires two AA batteries (supplied).
1. While pressing in on the catch, open cover in
direction of arrow.
2. install the batteries as shown in the battery
compartment.
{Polarity + or - must match the markings in the
compartment).
Two AA size
3. Press cover _n direction of arrow until it snaps
shut.
(1) For frequent remote control users, replace old
batteries with Alkaline batteries for longer battery
life.
(2) Whenever you remove the batteries, you may
need to reset the remote control infrared
codes. We recommend that you record the code
on pages 58°59, prior to setting up the remote.
If a CableCARD TM is installed, the cable MSO
(mu!tip!e system owner/operator) may provide an
Emergency A_ert System message. These messages
are intended to a!ert the general public of important
IocaJ or nationaJ emergency situations. In the event
of receipt of one of these messages, the Projection
Disp!ay sha!l immediately tune to the channeJ as
directed bythe EAS message. If the channel has
been blocked using the parental control, the parental
b!ock!ng has pr!ority over the forced tune.
Incorrect battery installation can cause the batteries to
leak. leading to personal injury and/or damage to the
remote control.
Observe the following precautions:
1. Batteries should always be replaced as a pair.
Always use new battenes when replacing the old
set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon"
with "Alkaline").
4. Do not attempt to charge, short=circuit, disassemble,
heat or burn used batteries.
5. Battery replacement is necessary when the remote
control acts sporadically or stops operating the
Projection Display set.
Use when moving unit to a new location, or First Time
Press the VOL= button on the unit
and OK button on the Remote
L+
('_I r_ L+ control at the same time for more
than 3 seconds. When reset is done,
,, power shuts off automatically.
7
Loading ...
Loading ...
Loading ...