Loading ...
Loading ...
Loading ...
The Po_xer Indicator
LED
Off
Red (blinking)
Green
Green (blinking)
ACTION
Power = OFF
Power - OFF (Now cooling)
Power = ON
Power - ON (Preparing to light lamp)
" !f_he ROWER button is accidentally turned off during use,
after power iS turned back on, it may take a short period
before the !amp automatically comes on.
o After the unit iS turned on, maximum picture brightness will be
acNeved !n 5-10 minutes. This is normal
• This uNt consumes approx. 0.3 W (15W when CableCARD TM
is inserted,)in OEF cendRion when plugged into an AC outlet.
Press POWER on Projection Display or Remote Control
The Power Indicator blinks Green for about 20 seconds
and then turns solid Green,
Always be sure to follow the procedure given below to
turn the Projection Display power ON and OFF.
• The lamp ceoIing fan will continue to operate for
approximately 1 minute after the power is turned off. During
this time, the POWER indicator will blink Red.
DO not disconnect the power cord from the outlet
and do not open the circuit breaker (unless
necessary) whi!e the cooling fan is still operating. Do
not disconnect the power cord from the power outlet
while the power indicator blinks Red.
POWER button/
POWER indicator
PreSSPOWER on projection Display or Remote Control
to turn Power 0fL
Power shuts off after a Black Screen is displayed for a
°!f the POWER button iS pressed during the Black Screen
disp!ay, Power is turned back on.
The Rower !ndicator b!!nks Red for about 1 minute and
then LED turns off.
° When the power cord is disconnected, the internal cooling
fan Stops operating, hthis case, the lamp will be insufficiently
cooled and wi!l take a while to turn ON again.
Auto shut off
To extend lamp life, if there is no signal to the
set's tuner for 5 minutes, the lamp will shut off
automatically.
24
Loading ...
Loading ...
Loading ...