Loading ...
Loading ...
Loading ...
129
Installation
www.bora.com
EN
O
A minimum clearance of 120 mm between the
back panel of the unit and an adjacent kitchen
unit or room wall must be observed for the air
duct.
O
No false floor is necessary below the cooktop.
If cable protection (false floor) is planned, the
following must be taken into account:
O
It must be fitted in such a way that it can be
removed from below for maintenance work.
O
To ensure sufficient cooktop ventilation, a
minimum distance of 15mm to the bottom
edge of the cooktop is to be observed.
O
The drawers and/or shelves in the floor unit must
be removable.
O
For correct installation, the drawers of the
floor unit must be shortened depending on the
installation situation.
10.6.2 Installation dimensions
min.
600
min.
50
199
120
540
(min.
424)
max.
430
60
min.
455
min.
329
min.
100
97
310
PUXA Abluft
(Insel):
PUXU
(Zeile
600):
PUXA Abluft
(Zeile
600):
BORA X
Pure
BO RA LÜFTU N GSFIBELXX
min.
600
min.
50
199
495
-
575
0
-
80
min.
25
525
(min.
495)
125
700
(min.
600)
min.
50
199
120
640
530
(min.
314)
min.
455
50
min.
279
min.
100
97
60
310
PUXU
mit
zusätzlichem Teleskopauszug
PULBTA (Insel):
min.
675
min.
50
199
600
-
680
105
-
185
min.
25
min.
600
125
Fig. 10.9 Installation dimensions for exhaust air,
worktop depth 600 mm
10
10 - 40
Fig. 10.8 Overlay dimensions for surface mounting
10.6 Installing the appliance in
exhaust air mode (PURSA)
i
National and regional laws and regulations
must be observed with regard to the exhaust
duct design.
i
A sufficient air supply must be ensured
i
The exhaust air must be directed to the
outside by appropriate exhaust air ducts.
i
The minimum cross-section of the air ducts
must be 176 cm
2
, which equates to a round
pipe with a diameter of 150 mm or the BORA
Ecotube duct system.
i
As a general rule, with the built-in fan, a length
of duct of up to 6 metres with six 90° bends,
8 metres with four 90° bends or 10 metres
with two 90° bends can be installed.
i
Not compatible with BORA Universal fans.
i
You can find planning instructions for
installation of the exhaust air ducts in the
BORA planning guide.
10.6.1 Preparing kitchen units for the
exhaust air model
O
Cross bars on the kitchen unit in the area of the
worktop cut-out may need to be removed.
O
In the case of thin worktops, there must be a
sufficiently rigid support plate on the unit.
O
The back panel of the floor unit must be adapted
for the exhaust air duct.
Loading ...
Loading ...
Loading ...