Loading ...
Loading ...
Loading ...
121
Cleaning and maintenance
www.bora.com
EN
8.6 Replacing the activated
charcoal filter
An activated charcoal filter will only be fitted with
the stainless steel grease filter if the cooktop
extractor is used in recirculation mode. The
activated charcoal filter absorbs cooking odours that
arise during cooking.
i
The activated charcoal filter must be replaced
when the fan indicator shows
F
(filter service
display). You can obtain the activated charcoal
filter PUAKF from your specialised retailer or
by contacting BORA via the website at
www.bora.com/filter.
X Make sure that the cooktop and cooktop
extractor are switched off (see
„6 Functions and
operation“
).
X Wait until the fan indicator shows
0
.
Removing the activated charcoal filter
X Remove the air inlet nozzle and stainless steel
grease filter.
2
1
Fig. 8.4 Remove the lter replacement cover
[1] Filter replacement cover
[2] Inlet opening
X Inside the inlet opening [2] pull the filter
replacement cover [1] out through the opening in
the filter housing.
1
2
5 4 3
Fig. 8.3 Air guiding housing
[1] Air guiding housing
[2] Housing base
[3] Spigot
[4] Sealing groove
[5] Lock
X Hold the housing base [2] with one hand.
X Release the 6 locks [5] around the edge of the
base.
X Remove the housing base [2].
X Clean the air guiding housing [1] and the housing
base [2] with a mild cleaning agent.
Closing the air guiding housing
X Position the housing base [2] under the air guiding
housing [1] with the help of the 3 spigots [3].
X Push the housing base [2] upwards into the
sealing groove [4].
X Close the 6 locks [5].
X Check that the housing base is positioned
correctly.
X Inside the inlet opening push the filter
replacement cover until it comes to a stop in
the filter housing opening (to insert the filter
replacement cover see Fig. 8.10).
X Check that the filter replacement cover is
positioned correctly.
X Insert the stainless steel grease filter and the air
inlet nozzle.
Loading ...
Loading ...
Loading ...