Loading ...
Loading ...
Loading ...
Removable light
Fig. 152
Removable light
Fig. 153
Removing light/inserting light
Read and observe and on page 107 first.
The lamp is for the illumination of the luggage compartment or it can be used
as a portable lamp.
The lamp is equipped with a magnet. As a result, this can, for example, be fitted
to the vehicle body.
Description of the light » Fig. 152
Button to turn the light that has been removed on / off
Part that lights up when the lamp is in the mount
Part that lights up when the lamp is not in the mount
If the light is in the mount, this will illuminate when the boot lid is opened.
›
To remove, hold the light in the area
D
and swivel in the direction of arrow
1
» Fig. 153.
A
B
C
›
To switch on the removed light, press button
A
» Fig. 152. Pressing the light
again will switch it off.
›
To insert, first of all insert the light with the rear part
E
into the mount
» Fig. 153 and then push the light in the direction of arrow
2
until it audibly
clicks into place.
If the light is not switched off and is correctly inserted in the mount, the LED
diodes in the front part of the light
C
» Fig. 152 are automatically switched off.
If the lamp is not correctly inserted into the holder, this does not light up when
the boot lid is opened and the rechargeable batteries are not charged.
Lamp charges
The lamp is supplied by three rechargeable type NiMH AAA batteries (voltage
1.2 V). The batteries are charged continuously with the engine running (to fully
charge the battery takes approximately 3 hours).
Replace batteries » page 298.
CAUTION
The light is not waterproof, so it must be protected from humidity - otherwise
there is risk of damage.
Class N1 vehicles
Read and observe and on page 107 first.
In class N1 vehicles that are not fitted with a protective grille, a lashing set that
complies with the EN 12195 standard (1-4) must be used for fastening the load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.
Variable loading floor in the luggage compartment (Estate)
Introduction
In its five-seat variant of the variable loading floor of two panels. The panels
can be handled separately.
In the seven-seat variant of the variable loading floor consists of one panel.
113
Transport of cargo
Loading ...
Loading ...
Loading ...