Loading ...
Loading ...
Loading ...
67English
Oven Maintenance
Removing/Re-installing the Oven Door
The 30" oven door weighs 42 lbs (19 kg). Grasp the door with both hands. Do not lift by the handle.
1. Open the oven door fully.
2.
locks toward you to unlock them. If the hinge locks are
not fully forward (see left), you cannot remove the door.
3. Partially close the door to engage the hinge locks. (The
door stops at this point.)
4. Grasp the sides of the door below the handle, and as
you pull, gently jiggle the door side to side as needed to
loosen it.
5. Set the door down without damaging the LED cable at the
6.
(handle-down), on the blanket you prepared.
7. When ready to re-install the door, stand at the top of the
door, grasp each side below the handles, and take the
door to the oven.
8. Set the door down, and connect the wire harness.
9. Holding the door at a 45° angle, insert the hinges in the
slots. (A slight drops engages the hinges.)
10. Fully open the door. (If it does not open 90°, repeat Steps
7 – 9.)
11. Flip the hinge locks forward to lock them, and close the
door. (The gap between door and control panel should be
even; if not, the hinge on the wide end of the gap is not
seated properly.)
12. Stuff the wire harness into its hole, and re-insert the
rubber seal.
Loading ...
Loading ...
Loading ...