Loading ...
Loading ...
Loading ...
Building in the appliance
94
Fitting the anti-tip device on a con-
crete floor.
Drill three holes in the floor to match
the holes on the anti-tip device. The
drill holes must have a diameter of
3/8" (10 mm) and be a little deeper
than the length of the concrete bolts
supplied.
Place or screw the washers and
hexagonal nuts onto each of the con-
crete dowels.
Secure the anti-tip device to the floor
with the concrete dowels.
Align the anti-tip device with the cen-
ter line again.
Then use the nuts to tighten the con-
crete dowels.
Now secure the anti-tip device to the
wall with the three screws
(1/4"x2-1/8" / 6 x 54 mm).
Fitting the anti-tip device on a
wooden floor
Secure the anti-tip device to the floor
with the five screws (1/4"x2-1/8" / 6
x 54mm). Pre-drill the holes if neces-
sary.
Now secure the anti-tip device to the
wall with the three screws
(1/4"x2-1/8" / 6x54mm).
Loading ...
Loading ...
Loading ...