Loading ...
Loading ...
Loading ...
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program while
keeping the HomeLink indicator light in
view.
3. Push and hold the HomeLink button you
want to program while you push and hold the
hand-held transmitter button.
4. Continue to hold both buttons and observe
the indicator light. The HomeLink indicator
will flash slowly and then rapidly after
HomeLink has received the frequency signal
from the hand-held transmitter . Release
both buttons after the indicator light
changes from slow to rapid.
5. Push and hold the programmed HomeLink
button and observe the indicator light.
• If the indicator light stays on constantly,
programming is complete and the garage
door/device should activate when the
HomeLink button is pushed.
• To program the two remaining HomeLink
buttons, repeat each step for each re-
maining button. DO NOT erase the
channels.
Reprogramming A Single HomeLink Button
(Non-Rolling Code)
To reprogram a channel that has been previously
trained, follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink button
until the indicator light begins to flash after
20 seconds. Do not release the button.
3. Without releasing the button, proceed with
“Programming A Non-Rolling Code” step
two and follow all remaining steps.
Canadian/Gate Operator Programming
For programming transmitters in Canada/
United States that require the transmitter sig-
nals to “time-out” after several seconds of
transmission:
Canadian radio frequency laws require trans-
mitter signals to time-out (or quit) after several
seconds of transmission, which may not be long
enough for HomeLink to pick up the signal
during programming. Similar to this Canadian
law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during
the cycling process to prevent possible over -
heating of the garage door or gate motor.
1. Cycle the ignition to the ON/RUN position.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program while
keeping the HomeLink indicator light in
view.
3. Continue to push and hold the HomeLink
button while you push and release (“cycle”)
your hand-held transmitter every two sec-
onds until HomeLink has successfully ac-
cepted the frequency signal. The indicator
light will flash slowly and then rapidly when
fully trained.
4. Watch for the HomeLink indicator to change
flash rates. When it changes, it is pro-
grammed. It may take up to 30 seconds or
longer in rare cases. The garage door may
open and close while you are programming.
GETTING TO KNOW YOUR VEHICLE
42
Loading ...
Loading ...
Loading ...