Loading ...
Loading ...
Loading ...
WINDSHIELD WIPER AND WASHERS
The wipers and washers are operated by a
switch within the multifunction lever . Rotate the
end of the multifunction lever to select the
desired wiper speed.
NOTE:
Always remove any buildup of snow that pre-
vents the windshield wiper blades from return-
ing to the off position. If the windshield wiper
switch is turned off and the blades cannot
return to the off position, damage to the wiper
motor may occur.
WARNING!
Sudden loss of visibility through the wind-
shield could lead to a collision. Y ou might not
see other vehicles or other obstacles. To avoid
sudden icing of the windshield during freez-
ing weather , warm the windshield with the
defroster before and during windshield
washer use.
Windshield Wiper Operation
Rotate the end of the lever upward, to the first
detent past the intermittent settings for low-speed
wiper operation. Rotate the end of the lever upward
to the second detent past the intermittent settings
for high-speed wiper operation.
Intermittent Wiper System
Use the intermittent wiper when weather condi-
tions make a single wiping cycle with a variable
pause between cycles desirable. Rotate the end
of the multifunction lever to the first detent
position, and then turn the end of the lever to
select the desired delay interval. There are five
delay settings, which allow you to regulate the
wipe interval from a minimum of one cycle every
second to a maximum of approximately 36 sec-
onds between cycles. The delay intervals will
double in duration when the vehicle speed is
10 mph (16 km/h) or less.
Windshield Washers
To use the windshield washer, push on the end of
the lever to the second detent and hold while spray
is desired. If the lever is pushed while on the
intermittent setting, the wipers will turn on and
operate for several wipe cycles after the lever is
released, and then resume the intermittent inter-
val previously selected. If the lever is pushed while
the wipers are in the off position, the wipers will
operate several wipe cycles, then turn off.
Mist Feature
Push the end of the multifunction lever inward
(toward the steering column) to the first detent
and release for a single wiping cycle.
NOTE:
The mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed
on the windshield. The wash function must be
used in order to spray the windshield with
washer fluid.
Rear Wiper And Washer
Rotating the center ring of the wiper lever to the
first detent activates the rear intermittent wip-
ers. To activate the washers, rotate the center
ring fully forward and the washers will spray
until the ring is released, and then resume the
intermittent interval.
NOTE:
Rear window wipers function in the intermittent
wiper speed only.
25
Loading ...
Loading ...
Loading ...