Loading ...
Loading ...
Loading ...
WARNING!
• Drivers must be careful when backing up
even when using ParkSense. Always check
carefully behind your vehicle, look behind
you, and be sure to check for pedestrians,
animals, other vehicles, obstructions, and
blind spots before backing up. Y ou are
responsible for safety and must continue
to pay attention to your surroundings. Fail-
ure to do so can result in serious injury or
death.
• Before using ParkSense, it is strongly rec-
ommended that the ball mount and hitch
ball assembly is disconnected from the
vehicle when the vehicle is not used for
towing. Failure to do so can result in injury
or damage to vehicles or obstacles be-
cause the hitch ball will be much closer to
the obstacle than the rear fascia when the
loudspeaker sounds the continuous tone.
Also, the sensors could detect the ball
mount and hitch ball assembly, depending
on its size and shape, giving a false indi-
cation that an obstacle is behind the ve-
hicle.
CAUTION!
• ParkSense is only a parking aid and it is
unable to recognize every obstacle, includ-
ing small obstacles. Parking curbs might
be temporarily detected or not detected at
all. Obstacles located above or below the
sensors will not be detected when they are
in close proximity.
• The vehicle must be driven slowly when
using ParkSense in order to be able to stop
in time when an obstacle is detected. It is
recommended that the driver looks over
his/her shoulder when using ParkSense.
PARKVIEW REAR BACK UP
CAMERA
Your vehicle is equipped with the ParkView Rear
Back Up Camera that allows you to see an
on-screen image of the rear surroundings of
your vehicle whenever the gear selector is put
into REVERSE. The image will be displayed on
the touchscreen or if equipped, in the rearview
mirror. If the image is displayed in the Uconnect
screen, a caution note to “check entire sur -
roundings” across the top of the screen.
After five seconds this note will disappear . The
ParkView Rear Back Up Camera is located on
the rear of the vehicle, above the rear license
plate.
Manual Activation Of The Rear View Camera:
1. Press the "Controls" button located on the
bottom of the Uconnect display.
2. Press the "Backup Camera" button to turn
the Rear View Camera system on.
When the vehicle is shifted out of REVERSE,
the rear camera mode is exited and the last
selected touchscreen appears again.
When the vehicle is shifted out of REVERSE
(with Camera delay turned on), the rear Camera
image will be displayed for up to 10 seconds
after shifting to another gear , unless the vehicle
speed exceeds 8 mph (13 km/h), the transmis-
sion is shifted into P ARK, the ignition is
switched to the OFF position, or the touch-
screen button “X” to disable display of the Rear
View Camera image is pressed.
STARTING AND OPERATING
114
Loading ...
Loading ...
Loading ...