Loading ...
Loading ...
Loading ...
7
Getting Started
IMPORTANT – Please Read and Follow!
Grounding Instructions
Service
• Should this appliance require service, please
call Viking Range, LLC at 1-888-(845-4641). A
quali ed service representative will assist you
and if required, coordinate a service visit by
an authorized service agent in your area.
Power Connections
• To avoid potential hazards, only the
manufacturer, its service agent, or a similarly-
quali ed person should replace a damaged
power cable. Flexible conduit, conductors and
connectors are supplied by the manufacturer.
The oven must be connected using the
exible conduit and conductors provided.
Self-Cleaning Oven Guidelines
• Clean the oven only in accordance with the
guidelines provided on page 49.
• Before self-cleaning the oven, remove broiler
pan, grid, racks, and other cookware. Clean
only parts listed in manual.
• Listen for fan—a fan noise should be heard
during the self-cleaning cycle. If not, call
Viking Range, LLC at 1-888-(845-4641) before
self-cleaning again.
• DO NOT clean the door gasket. The door
gasket is essential for a good seal.
DO NOT to rub, damage, or move the gasket.
• DO NOT use oven cleaners. No commercial
cleaner or oven liner protective coating of any
kind should be used in or around any part
of the oven. Residue from oven cleaners will
damage the inside of the oven when the self-
clean mode is used.
• In the event the oven is malfunctioning in
the self-clean mode, turn the oven o or
disconnect it from the power supply and call
Viking Range, LLC at 1-888-(845-4641).
• Complete instructions on the operation
of the self-clean mode can be found on page
49.
RF Interference Considerations
• The appliance has been tested and
was determined to be in compliance
with applicable portions of FCC part 18
requirements and with the protection
requirements of Council Directive 89/336/
EEC on the approximation of the laws of the
European Union Member States relating to
electromagnetic compatibility at the time of
manufacture. However, some equipment with
sensitivity to signals below these limits may
experience interference.
• If any equipment experiences interference,
the following steps should be considered:
o Increase the physical distance between the
sensitive equipment and this oven.
o If the sensitive device can be grounded, do
so following accepted grounding practices.
o If battery-powered microphones are being
a ected, ensure that the batteries are fully
charged.
o Keep sensitive equipment on separate
electrical circuits if possible.
o DO NOT route intercom wires, microphone
wires, or speaker cables near the oven.
SAVE THESE INSTRUCTIONS
Loading ...
Loading ...
Loading ...