Loading ...
Loading ...
Loading ...
Function
31
1. Press the MENU button. Then, move to OPTION with the ∧, ∨,
＜, ＞ buttons and press the ◉OK button.
2. Press the ∧, ∨ buttons to move to Set ID and press the ◉OK
button.
3. Press the ＜, ＞ button to select your desired number. Press the
◉OK button to save the selected number.
• The adjustment range of Set ID is 1~99.
• Only the projector with the specified ID number will operate from the
remote control.
• Press the BACK button to exit the menu screen.
OPTION
Menu Language : English
Blank Image : Blue
Screen Capture
Lamp Mode : Normal
Monitor Out : RGB1
Set ID : 1
Network Setting
High Altitude : Off
3D Mode
ꔂMove ꔉOK
SET ID
* Connect the serial port of the PC to the RS-232C jack on the projector back panel.
* RS-232C cable is not supplied with the projector.
* Use the RS232C cable to control the projector externally (Refer to Fig.1).
<Fig.1, RS-232 Interface Cable>
* 1, 9 Pin No Connection
2
3
4
5
6
7
8
RXD
TXD
DTR
GND
DSR
RTS
CTS
RXD
TXD
DTR
GND
DSR
RTS
CTS
2
3
4
5
6
7
8
PC
Projector
Communication Parameter Setup
•
Baud Rate : 9600bps(UART)
•
Data Length : 8bit
•
Parity : none
•
Stop bit : 1bit
•
Flow Control : none
•
Communication code : ASCII code
9 6
15
How to connect external control equipment
Loading ...
Loading ...
Loading ...