Loading ...
Loading ...
Loading ...
Switching back to single sheets
To switch to single sheets, press the Load/Eject button; the printer feeds the paper backwards into the standby position.
Then, follow the steps in Loading single sheets.
Caution:
Always tear off your printed document before you press the Load/Eject button. Reverse feeding several
pages at a time may cause a paper jam.
Top
Adjusting the top-of-form position
The top-of-form position is the position on the page where the printer starts printing. If your printing appears too high or low
on the page, you can use the micro adjust feature to adjust the top-of-form position. Follow these steps:
Caution:
Never use the paper feed knob to adjust the top-of-form position; this may damage the printer or cause it to
lose the top-of-form position.
Note:
Your top-of-form position setting remains in effect until you change it, even if you turn off the printer.
The top margin setting made in some application software overrides the top-of-form position setting
you make with the Micro Adjust feature. If necessary, adjust the top-of-form position in your software.
Make sure the printer is turned on.
If necessary, load paper as described in this chapter.
Remove the printer cover.
Hold down the Pause button for about three seconds. The Pause light starts flashing and the printer enters the Micro
Adjust mode.
Press the LF/FF button to move the top-of-form position down on the page, or press the Load/Eject button to
move the top-of-form position up on the page.
* plastic ribbon cover
Note:
Loading ...
Loading ...
Loading ...