Loading ...
Loading ...
Loading ...
53
Troubleshooting
Problem Cause Action
There is excess flour around
the bottom and sides of my
bread.
l
You have used too much flour, or you are not using enough liquid.
Check the recipe and measure out the correct amount using scales for the flour or the
sourdough cup provided for liquids.
Why has my bread not mixed
properly?
l
You haven’t put the kneading blade in the bread pan.
Make sure the kneading blade is in the bread pan before you put in the ingredients.
l
There has been a power failure, or the machine has been stopped during breadmaking.
The machine switches off if it is stopped for more than 10 minutes. You might be able to start
the loaf again, though this might give poor results if kneading had already begun.
l
The kneading mounting shaft in the bread pan is stiff and does not rotate.
If the kneading mounting shaft does not rotate when the blade is attached, you will need
to replace the kneading mounting shaft unit (consult the place of purchase or a Panasonic
Accessory Shop: 0844 8443899 or order online at https://www.pas-europe.com).
My bread has not been baked.
l
The dough menu was selected.
The dough menu does not include a baking process.
l
There has been a power failure, or the machine has been stopped during breadmaking.
The machine switches off if it is stopped for more than 10 minutes. You can try baking the
dough in your oven if it has risen and proved.
l
There is not enough water and the motor protection device has activated. This only happens
when the unit is overloaded and excessive force is applied to the motor.
Visit place of purchase for a service consultation. Next time, check the recipe and measure
out the correct amount using the sourdough cup provided for liquid and scales for weighing
flour.
Dough leaks out of the bottom
of the bread pan.
l
A small amount of dough will escape through
the four holes (so that it does not stop the
rotating parts from rotating). This is not a
fault, but check occasionally that the kneading
mounting shaft rotate properly.
If the kneading mounting shaft does not
rotate when the kneading blade is attached,
you will need to replace the kneading
mounting shaft unit (consult the place of
purchase or a Panasonic Accessory Shop:
0844 8443899 or order online at
https://www.pas-europe.com).
Dough release holes
(4 in total)
(Bottom of bread pan)
Kneading mounting shaft
Kneading mounting shaft unit
Part no. ADA29E165
The sides of my bread have
collapsed and the bottom is
damp.
l
You have left the bread in the bread pan for too long after baking.
Remove the bread promptly after baking.
l
There has been a power failure, or the machine has been stopped during breadmaking.
The machine switches off if it is stopped for more than 10 minutes. You may try baking the
dough in your oven.
The kneading blade rattles.
l
This is because the kneading blade fits loosely on the kneading mounting shaft. (This is not a
fault)
SD-2511_UK.indd 53 2015/01/09 15:29:38
Loading ...
Loading ...
Loading ...