Loading ...
Loading ...
Loading ...
Frequently asked questions
94
With the help of the following guide, minor faults in the performance of the appliance,
some of which
may result from incorrect operation, can be corrected without contacting
the Service Department.
Please note that a call-out fee will be applied to unnecessary service visits where the
problem coul
d have been rectified as described in these operating instructions.
Repair work to electrical appliances must only be carried out by a suitably qualified
person
in strict accordance with current local and national safety regulations. Repairs
and other work by unqualified persons could be dangerous. The manufacturer cannot be
held liable for unauthorized work.
Technical problems
Problem Possible cause and solution
When the dishwasher is
turned on with the
but
ton, the display stays
dark and the Start/Stop
indicator does not flash.
The dishwasher is not plugged in.
Insert the plug.
The circuit breaker has tripped.
Reset the cir
cuit breaker
(minimum fuse rating - see data plate).
The dishwasher stops
during a pr
ogram.
The circuit breaker has tripped.
Reset the cir
c
uit breaker (see data plate for the correct
fuse rating).
If the circuit breaker trips again, contact Miele Customer
Ser
vice.
One of the following fault
messages is displayed:
Before fixing the fault:
T
urn the dishwasher off with the button.
Check water intake There is a problem with the water intake.
O
pen the faucet all the way.
Clea
n the filter in the water inlet (see "Cleaning and
car
e").
Fault 403-405 If Check water intake a
ppears in the display, the control unit
is checking the water intake approx. every 30 seconds. If,
after three attempts, water is not getting into the
dishwasher, one of these numbers will appear in the display
and the program will be cancelled.
Open the faucet all the way
.
T
urn the dishwasher back on.
Select the desir
ed pr
ogram.
P
ress the Start/Stop button.
Loading ...
Loading ...
Loading ...