Loading ...
Loading ...
Loading ...
Emergencies
Rear towline anchorage
Fig. 47
On the right side of the rear bumper:
r
emove the cover.
Fig. 48 On the right side of the rear bumper:
t
owline anchorage in position.
The housing of the screw towing eye is on the
right side of the r
ear bumper behind a lid
›››
Fig. 47.
Vehicles equipped as standard with a towing
bracket do not have any housing for the
screw towing eye behind the lid. In this case,
the tow hitch needs to be extracted or instal-
led and used for towing
›››
page 288,
›››
.
Bear in mind the instructions f
or towing
›››
page 53.
Assemble the rear towing eye (cars with-
out a factory-equipped towing bracket)
●
Remove the towing eye from the vehicle
tool kit in the luggage compartment
›››
page 41.
●
Press the upper side of the lid
›››
Fig. 47 to
unclip it.
●
Remove the lid and let it hang from the ve-
hicle.
●
Screw the towline anchorage into the hous-
ing by turning it as far as it will go anticlock-
wise
›››
Fig. 48
›››
. Use a suitable object
that can compl
etely and securely tighten the
towing eye in its housing.
●
After towing, unscrew the towing eye
clockwise with a suitable object.
●
Insert the upper flange of the lid into the
opening of the bumper and press the lower
side of the lid until the upper flange is inserted
into the bumper.
●
Clean the towing eye if necessary and then
store it in the luggage compartment along
with the other vehicle tools.
CAUTION
●
The t
owing eye must always be com-
pletely and firmly tightened. Otherwise, it
could be released while towing and tow-
starting.
●
If the vehicle is factory-equipped with a
towing bracket, it is only allowed to tow
with a tow bar if this has been specially de-
signed to be installed with a tow hitch. If an
unsuitable tow bar is used, both the tow
hitch and the vehicle may be damaged. In-
stead, a tow rope should be used.
56
Loading ...
Loading ...
Loading ...