User Manual - Page 213

For ATECA 2021.

Loading ...
Loading ...
Loading ...
Start and driving
The engine can only be started and stopped
in those positions.
Engage position P; the vehicle can
move; doors can only close in posi-
tion P.
For safety reasons, this driver message ap-
pears and an audibl
e warning sounds if the
selector lever of the automatic gearbox is not
in position P after you switch off the ignition.
Move the selector lever to the P position, oth-
erwise the vehicle could move.
Gear change: selector lever in the
drive position!
This driver message is displayed when the
selector lever is not in the position P when the
driver door is opened. Additionally, a buzzing
sound is emitted. Put the selector lever in po-
sition P, otherwise the vehicle could roll away.
Ignition is switched on
This driver message is displayed and a buz-
zer is sounded when the driver door is
opened with the ignition switched on.
Start-Stop system
Control lamps
It lights up
The Start-Stop system is available, the automatic en-
gine shutdown is active.
It lights up
The Start-Stop system is not available or has been
disconnect
ed.
Instructions for the driver on the instru-
ment panel displ
ay
Start-Stop system deactivated. Start
the engine manually
This indication for the driver shows that the
Start-Stop system cannot start the engine
again.
Start-Stop system: Fault! Function
not available
There is a fault in the Start-Stop system.
Take the vehicle to a workshop to have the
fault repaired.
Description and operation
The Start-Stop system helps you to save fuel
and r
educe CO
2
emissions.
In Start-Stop mode, the engine will automati-
cally switch off when the vehicle stops or is
stopping. The ignition remains switched on.
The engine automatically switches back on
when required.
In this scenario, the light of the   
button stays lit
1)
.
When the ignition is s
witched on, the Start-
Stop function is automatically activated.
Vehicles with a manual gearbox
When the vehicle or when it is stopped, put
it int
o neutral and release the clutch pedal.
The engine will switch off. The warning lamp
will light up. The engine can be stopped
before stopping completely (approximately 7
km/h).
When the clutch pedal is pressed the en-
gine will start up again. The warning lamp will
switch off.
Vehicles with an automatic gearbox
Brake until the vehicle has come to a stand-
still, and keep your foot on the brake pedal or
»
1)
Only in vehicles with Keyless Access.
211
Loading ...
Loading ...
Loading ...