Loading ...
Loading ...
Loading ...
© 2017 DJI All Rights Reserved.
47
AGRAS MG-1S User Manual
Take off immediately after the motors are spinning, or else the aircraft may drift and cause
damage or harm.
Rotating propellers can be dangerous. DO NOT start the motors in narrow spaces or
when there are people nearby.
Always keep your hands on the remote controller when the motors are spinning.
If you perform the CSC when the aircraft is airborne, the motors will stop and cause the
aircraft to crash. Never stop the motors mid-ight, unless in emergency situations when
doing so can reduce the risk of damage or harm.
When using method 2 to stop the motors, the aircraft may tip if it doesn’t touch the ground
completely. Please use method 2 with caution. It is recommended to stop the motors via
method 1.
Flight Test
1. Place the aircraft near the operation area with the Aircraft Status Indicator facing you.
2. Power on the remote controller. Connect the battery to the communication port, then the XT90
port.
3. Go to Operation View in the DJI MG app > > > Connected DJI Device Type. Make sure to
choose “MG-1S”. Set the Flight Mode switch to P and the Operation Mode switch to M.
4. When using with the MG-1S RTK aircraft:
Ensure that the “RTK Module” is enabled and RTK data source is correctly set (D-RTK Base
Station). Go to Operation View in the DJI MG app > > RTK > RTK Module to enable “RTK
Module” and select the correct data source.
Make sure to disable “RTK Module” if RTK is not used. Otherwise, the aircraft cannot take off
when there is no RTK data.
5. When the GNSS signal is strong, perform the CSC command to start the motors.
6. Push the throttle stick up to take off.
7. Select the desired operation or ight mode and spray liquid.
8. Exit the task to manually control the aircraft for landing. Hover over a level surface and gently pull
down on the throttle stick to slowly descend.
9. After landing, push the throttle down and hold. The motors will stop after three seconds.
10. Disconnect the battery from the XT90 port, then the communication port. Power off the remote
controller.
When the Aircraft Status Indicator rapidly blinks yellow during flight, the aircraft has
entered Failsafe mode.
The low battery level warning is triggered when the Aircraft Status Indicator slowly blinks
red. Fly the aircraft back and land it as soon as possible, stop the motors, and replace
the battery. The critical low battery level warning is triggered when the Aircraft Status
Indicator rapidly blinks red. The aircraft will begin to automatically descend and land.
Loading ...
Loading ...
Loading ...