Dji AGRAS MG-1S SERIES User Manual

Loading ...

AGRAS MG-1S User Manual

Operation Procedure

Maintain line of sight of the aircraft at all times.

Set the Flight Mode switch to P when GNSS signal is strong. Otherwise, Smart operation

mode may be unreliable.

Always inspect operating environments before ying.

Set the remote controller’s Flight Mode Switch to P when a strong GNSS signal is present. In addition,

set the Operation Mode switch to M.

1. Record Points A and B in Order

Users cannot set the Operation Mode switch to Smart operation mode until they have recorded

points A and B.

Fly the aircraft to the starting point, depicted as Point A/B, hover, and then press Button A/B on

the remote controller or tap Point A/B onscreen. The icon for Point A/B will change from gray to

purple and the Aircraft Status Indicator will blink red/green after recording the starting points.

Points A and B cannot be recorded if the spray tank is empty.

Update Point B by ying the aircraft to a new position to record. Note that if you update

Point A, you must also update Point B.

It is recommended to keep the direction of Point A to B parallel to one side of the

rectangular spray area for optimal effect.

After recording Point A, there will be a menu prompt for work type settings. Set the

amount of pesticide per acre and work type. Use the slider to adjust work efficiency.

During the task, tap the icon at the top of the screen to adjust parameters. You can also

adjust work efciency via the Settings dial on the remote controller.

The DJI MG app will display an icon of line spacing. Tap to adjust the value. The line

spacing cannot be adjusted during operation. Switch to Manual or Manual Plus operation

mode to adjust the value, then go back to Smart operation mode.

2. Select the Route

Press the C1 or C2 buttons on the remote controller to select the operating pattern. Press C1 for

Route L and C2 for Route R. The default route pattern is Route R if no selection has been made.

Users can select the route in Manual operation mode only. If the aircraft is in Smart

operation mode, select the route after switching to Manual operation mode.

3. Conguring Aircraft Altitude

Congure the desired altitude in the DJI MG app and adjust the aircraft altitude to a value within

the working range of the Radar Terrain Follow System (1.5-3.5 m) by using the throttle stick before

entering Smart operation mode. The Radar Terrain Follow System will start working automatically

and maintain the spraying distance between aircraft and vegetation. Refer to the Radar Terrain

Follow System for details.

4. Using Smart Operation Mode

Set the remote controller’s Flight Mode switch to P and ensure that a strong

GNSS signal is present, then set the Operation mode switch to S to enable

Smart operation mode.

Loading ...

Dji AGRAS MG-1S SERIES