Loading ...
Loading ...
Loading ...
© 2017 DJI All Rights Reserved.
13
Installation
Threadlocker is required for installation. Apply threadlocker when mounting the landing
gear, spray tank, sprinklers and power port modules. Ensure threadlocker is totally dry
and solid before ight.
DO NOT bend the hose in an arc tighter than its minimum bend radius during installation.
This is to avoid creasing, which may compromise the spraying effect.
Ensure that all installation and connection procedures are completed before powering on
the aircraft.
Installation steps are the same for both the MG-1S and MG-1S RTK. The illustrations below use the
MG-1S as an example.
Mounting the Hose Clip
5. Mount the left landing gear leg and tighten the three M3×10 screws.
Mount the self-adhesive hose clip to the outside of the right
landing gear leg mounting position (as shown) and tighten the
M3×6 screw.
Mounting the Landing Gear
1. Identify the landing gear leg containing the two compass cables.
2. Take out each compass cable from the tube of the landing gear leg. Looking from the rear of the
aicraft, connect each compass cable to the compass port on the right side of the aircraft body. Put
the assembled cable into the cable protector slot and close it. Be careful not to damage the cable.
3. Place each cable protector and cable into its corresponding mounting position on the aircraft
body then mount the right landing gear leg to the mounting position.
4. Insert the two anti-drop plates into the mounting position and tighten the three M3×10 screws.
Mounting to the upper screw hole
Anti-drop Plates
Compass Cable
Aircraft Rear
Compass Port
Cable Protector
Loading ...
Loading ...
Loading ...