Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
Important!
The instructions are intended for a skilled installation engineer.
The appliance must be installed correctly, in accordance with the relevant regulations.
All work must be carried out with the appliance disconnected from the electricity supply.
INSTALLATION:
The appliance must be installed by the purchaser. The Manufacturer is not obliged to provide this
service. Any work carried out by the Manufacturer on the purchaser's request further to installation
errors is not covered by the warranty.
If the hob is installed on top of a base unit with oven, suitable precautions must be taken in order to
ensure installation in compliance with safety standards (CEI - UNI - CIG). Take special care to
position the electrical cable and gas supply pipe so that they do not touch hot parts of the oven's
casing.
If an oven without cooling fan is installed underneath the hob, openings must be made in the built-in
installation cabinet to allow the air to circulate properly. These openings must ensure an unobstructed
surface of at least 300 cm2 distributed as shown in figure 23.
Installing the hob in the cabinet top
The hob can be installed in any cabinet which withstands a temperature of at least 90°C.
The size of the hole to be made in the cabinet top and the minimum distances from the surfaces
behind, beside and above the appliance are shown in figure 14 and 15.
Bear in mind that:
) When the hob is not installed in combination with an oven, a separator panel must be installed
between the bottom of the hob and the cabinet below, with a gap of at least 10 mm.
) If the hob is combined with an oven, install a partition with a gap of at least 15 mm and in all
cases assuring ventilation as specified in fig. 16.
In all cases, the electrical connections to the two appliances must be made separately,
both for electrical reasons and to simplify extraction.
Use of an oven with forced-air internal cooling system is recommended.
Fixing the hob
Secure the hob to the cabinet as follows:
) Fit the sealing gasket provided around the outside perimeter of the hole in the cabinet as shown
in fig. 14, so that the ends of the strips fit perfectly flush without overlapping.
) Place the hob in the hole in the cabinet, ensuring that it is centred.
) Fix the hob to the cabinet with the brackets provided as shown in fig. 17.
Fitting the sealing gasket properly provides full guarantees against the penetration of liquids.
Installation room and discharge of combustion products
) The appliance must be installed and operated in suitable premises, in accordance with
the relevant legislation. The installation engineer must refer to the relevant legislation on
ventilation and the extraction of combustion gases. Remember that the amount of air
required for combustion is 2m3/h for every kW of power (gas) installed.
31
Loading ...
Loading ...
Loading ...