Loading ...
Loading ...
Loading ...
20
d
Tighten the screws on the left and right sides of the
thread guide assembly.
1 Tighten screws.
Preparing the spool stand
a
Loosen the thumb screw two or three turns, and then
open up the spool stand to the left and right.
Rear view
1 Thumb screw
2 Spool stand
b
After the spool stand is fully opened up, tighten the
thumb screw.
Rear view
Secure the spool stand in the opened position.
Note
• If the screws are not loosened enough, it may not
be easy to move the thread guide assembly
support and the thread guide. Do not apply
extreme force when moving the thread guide
assembly support and the thread guide. Be sure
that the screws are loosened well enough before
moving these parts.
• Be sure to tighten each screw well enough that the
thread guide assembly support and the thread
guide are secured.
Note
• Using the 3-way screwdriver included, loosen and
firmly tighten the thumb screws.
1 Use this part to tighten the thumb screws of the
spool stand.
a
Loading ...
Loading ...
Loading ...