Loading ...
Loading ...
Loading ...
18
Setting up the machine
When setting up the machine, adjust the legs so that the
machine is steady.
a
Make sure that all packing tape affixed to the machine
is peeled off and that all packing material is removed.
b
Set up the machine while making sure that there is
sufficient space around it.
For details on the setup location, refer to page 17.
c
Adjust the legs so that the machine is steady.
Use the included wrench to loosen the lock nut on the
leg that you wish to adjust.
The foot can be turned.
d
Use the included wrench to turn the adjustable foot
nut on the foot.
Turning the nut in direction 1 lengthens the leg; turning
the nut in direction 2 shortens the leg.
• Adjust all four legs so that they securely contact the
desk or table, and the machine is level.
e
After adjusting the legs to the desired length, use the
included wrench to tighten the nuts.
f
Press down on each corner of the machine to check
that it is stable.
If it is still unstable, perform steps
c through e again
to adjust the legs.
Adjusting the operation panel position
a
Loosen 2 thumb screws to bring the operation panel
forward.
1 Thumb screws
b
Adjust the operation panel to an easy-to-operate
position, and then tighten the thumb screws.
c
Adjust the orientation of the operation panel.
Loosen the thumb screw, adjust the operation panel to
an easy-to-view orientation, and then tighten the thumb
screw.
1 Thumb screw
1 Lock nut
2 Adjustable foot nut
1 Adjustable foot nut
1 Lock nut
Note
• Using the 3-way screwdriver included, loosen and
firmly tighten the thumb screws.
1 Use this part to tighten the upper and lower
thumb screws.
2 Use this part to tighten the left and right thumb
screws.
a
b
Loading ...
Loading ...
Loading ...