Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 59
NOTE:
If the window runs into any obstacle during
auto-closure, it will reverse direction and then
go back down. Remove the obstacle and use
the window switch again to close the window.
Any impact due to rough road conditions may
trigger the auto-reverse function unexpectedly
during auto-closure. If this happens, pull the
switch lightly and hold to close the window
manually.
Window Lockout Switch
Window Lockout Switch
The window lockout switch on the driver's door
trim panel allows you to disable the window
controls on the rear passenger doors. To disable
the window controls, push and release the
window lockout button. The light on the window
lockout switch will illuminate to signal that the
feature has been activated and the passenger
windows can only be adjusted by the driver.
To enable the passenger window controls, push
and release the window lockout button again,
and the indicator light on the button will turn off.
Reset Auto-Up
Should the Auto-Up feature be interrupted and
stop working, the feature will need to be reset.
The following procedure will reset the Auto-Up
feature:
NOTE:
All doors must be closed before beginning the
Auto-Up reset procedure.
To reset Auto-Up, pull the window switch up to
close the window completely, and continue to
hold the switch up for an additional three
seconds after the window is closed. Then, push
the window switch down firmly to open the
window completely, and continue to hold the
switch down for an additional three seconds
after the window is fully open.
WARNING!
There is no auto-reverse protection when the
window is almost closed. To avoid personal
injury be sure to clear your arms, hands,
fingers and all objects from the window path
before closing.
2
2020_FIAT_500X_OM_USA=GUID-B0E0CFCD-ED13-4DFD-975F-620984F05523=1=en=.book Page 59
Loading ...
Loading ...
Loading ...