Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 181
Front Park Assist Audible Alerts
Park Assist will turn off the Front Park Assist
audible alert (chime) after approximately three
seconds when an obstacle has been detected,
the vehicle is stationary, and brake pedal is
applied. If the obstacle has been detected
within less than 12 inches (30 cm), then the
Park Assist will not turn off the Front Park Assist
audible alert.
Adjustable Chime Volume Settings
Front and Rear chime volume settings can be
selected from the Customer-Programmable
Features section of the Uconnect system, refer
to “Uconnect Settings” in “Multimedia” for
further information.
If the Uconnect system is equipped, chime
volume settings will not be accessible from the
instrument cluster display.
The chime volume settings include low,
medium, and high. The factory default volume
setting is medium.
Park Assist will retain its last known configura-
tion state through ignition cycles.
Enabling And Disabling Park Assist
Park Assist can be enabled and disabled with
the Park Assist switch, located on the switch
panel below the Uconnect display.
When the Park Assist switch is
pushed to disable the system, the
instrument cluster display will show
the “Park Assist Disabled” message
for approximately five seconds. Refer to “Instru-
ment Cluster Display” in “Getting To Know Your
Instrument Panel” for further information.
The Park Assist switch LED turns on when the
system is disabled by pushing the switch, as
well as in case of failure or temporary disabling
conditions. The Park Assist switch LED will be
off when the system is enabled. If the Park
Assist switch is pushed, and requires service,
the Park Assist switch LED will blink momen-
tarily, and then the LED will be on.
Service The Park Assist System
During vehicle start up, when the Park Assist
System has detected a faulted condition, the
instrument cluster display will actuate a single
chime, once per ignition cycle, and it will show
the "PARK ASSIST UNAVAILABLE WIPE REAR
SENSORS", "PARK ASSIST UNAVAILABLE WIPE
FRONT SENSORS", or the "PARK ASSIST
UNAVAILABLE SERVICE REQUIRED" message
for five seconds.
If "PARK ASSIST UNAVAILABLE WIPE REAR
SENSORS" or "PARK ASSIST UNAVAILABLE WIPE
FRONT SENSORS" appears in the instrument
cluster display make sure the outer surface and
the underside of the rear fascia/bumper and/or
front fascia/bumper is clean and clear of snow,
ice, mud, dirt or other obstruction and then
cycle the ignition. If the message continues to
appear see an authorized dealer.
If the "PARK ASSIST UNAVAILABLE SERVICE
REQUIRED" message appears in the instrument
cluster display, see an authorized dealer.
Cleaning The Park Assist System
Clean the Park Assist sensors with water, car
wash soap and a soft cloth. Do not use rough or
hard cloths. Do not scratch or poke the sensors.
Otherwise, you could damage the sensors.
5
2020_FIAT_500X_OM_USA=GUID-B0E0CFCD-ED13-4DFD-975F-620984F05523=1=en=.book Page 181
Loading ...
Loading ...
Loading ...