Loading ...
Loading ...
Loading ...
4
RS232-C Data Port Cable
The RS232 Data Cable is a 3.5mm stereo mini phone
plug to a subminiature DB 9 connector:
Output Terminal Connector
When cables with spade lugs are used
for Loudspeaker Connection, the spade
lugs need an opening of at least 3/10 inch
(7.6m m).
McIntosh Plug-In Jumper Connector
The MAC7200 utilizes two phono style Plug-In Jump-
ers to connect the Preamplifier Output to the Power
Amplifier Input.
Note: The Jumper Connector is available from the McIn-
tosh Parts Department:
McIntosh Jumper Connector Part
No. 117781
FM Dipole Antenna
The MAC7200 FM Tuner Circuitry requires the con-
nection of an external Antenna for FM reception. A
“FM Dipole Antenna” is available from the McIntosh
Parts Department:
FM Dipole Antenna Part
No. 173033
XLR Connectors
Below is the Pin configuration for the XLR Balanced Input
Connectors on the MAC7200. Refer to the diagram for con-
nection:
PIN 1: Shield/Ground
PIN 2: + Output
PIN 3: - Output
Power Control and Trigger Connectors
The Power Control Trigger Output
Jacks send and Passthru Input Jack
receives Power On/Off Signals
(+12 volt/0 volt) when connected
to other McIntosh Components.
An additional connection is for
controlling the illumination of the
Power Output Meters on McIntosh
Power Amplifiers. A 3.5mm stereo mini phone plug is
used for connection to the Power Control, Trigger and
Passthru Outputs.
Data Port Connectors
The Data Out Ports send Remote
Control Signals to Source Compo-
nents. A 3.5mm stereo mini phone
plug is used for connection.
IR IN Port Connectors
The IR IN Port also uses a 3.5mm
stereo mini phone plug and allows
the connection of other brand IR
Receivers to the MAC7200.
Connector and Cable Information
Data
Signal
N/C
Data
Ground
Power
Control
Meter
Illumination
Control
Ground
Main, Trig 1&2
and Pass-Thru
PIN 1
PIN 2
PIN 3
IR Data
Control
Ground
N/C
General Information, Connector and Cable Information
PIN 1
PIN 6
PIN 5
PIN 9
Data In
(DB9-pin2)
Ground
(DB9-pin5)
Data Out
(DB9-pin3)
DB9
(male connector)
3/10 of an inch
(7.6millimeters)
McIntosh RAA2 AM Antenna
The AM Tuner Circuitry requires the connection
of the external McIntosh RAA2 Antenna for AM
reception. The RAA2 Antenna is supplied with the
MAC7200 Receiver. The “AM Antenna” is also avail-
able from the McIntosh Parts Department:
RAA2 AM Antenna with connecting cable
Part No. 31036400
Loading ...
Loading ...
Loading ...