McIntosh MAC7200 User Manual

Loading ...

5. Connect the MAC7200 power cord to an active

AC outlet.

Spade Lug or Wire Connections:

6. Connect the Loudspeaker hookup cables to the

MAC7200 Negative Output Terminal and Posi-

tive Output Terminal indentified as 2Ω (ohms),

4Ω (ohms) or 8Ω (ohms) connection to match the

impedance of the Loudspeaker, being careful to

observe the correct polarities. Insert the spade

lug connector or prepared section of the cable end

into the terminal side access hole, and tighten the

terminal cap until the cable is firmly clamped into

the terminals so the lugs or wire cannot slip out.

Refer to figures L and M.

Note: The illustration located on the separate folded

sheet “Mc2B” is for connection to an 8Ω

(ohms) Loudspeaker.

If the Loudspeaker’s impedance is in-between the

available connections, use the nearest lower im-

pedance connection. Refer to “General Informa-

tion” Note 6 on page 3 for additional information.

WARNING: Loudspeaker terminals are hazard-

ous live and present a risk of electric

shock. For additional instruction on

making Loudspeaker Connections con-

tact your McIntosh Dealer or McIn-

tosh Technical Support.

7. Connect the MAC7200 power cord to an active

AC outlet.

Connecting Loudspeakers

Figure L

Figure M

Loading ...

McIntosh MAC7200 Receiver