Loading ...
Loading ...
Loading ...
27
Setup, con’t and Reset of the Microprocessors
In the unlikely event the controls of the MAC7200
stop functioning, the microprocessors can be reset by
performing the following:
1. Press the STANDBY/ON Push-button until the
STANDBY/ON LED Indicator switches Off.
2. Then release the STANDBY/ON Push-button and
the MAC7200 will switch Off.
3. When the STANDBY/ON LED is illuminated
press the STANDBY/ON Push-button, the
MAC7200 will resume normal operation.
Note: This can be performed with the MAC7200 On
or in the Standby Mode.
Reset of the MicroprocessorsFactory Reset
If it becomes desirable to reset all the adjustable set-
tings (Setup and Trim Settings) to the factory default
values, perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 17.
2. Rotate the INPUT Control until “FACTORY RE-
SET, (Hold INPUT)” appears on the Information
Display. Refer to figure 61.
3. Press and hold in the INPUT Control until “FAC-
TORY RESET, In Progress!” appears on the Infor-
mation Display, then release the INPUT Control.
Refer to figures 62 and 63.
4. Press the Front Panel STAND/BY Push-button to
switch On the MAC7200.
Figure 63
FACTORY RESET
Completed!
Figure 61
FACTORY RESET
(Hold INPUT)
Figure 62
FACTORY RESET
In Progress!
Loading ...
Loading ...
Loading ...