Loading ...
Loading ...
Loading ...
31
Tone
Press the Front Panel TONE Push-button to activate
the MAC7200 TREBLE and BASS Tone Control
Circuitry for the currently selected Input Source. The
LED above the TONE Push-button will illuminate. To
bypass the TONE CONTROL CIRCUITRY for the
currently selected Input Source press the TONE Push-
button. The LED above the TONE Push-button will
extinguish.
Trim
Press the Front Panel INPUT/TRIM Control to acti-
vate the MAC7200 Trim Functions. Rotate the Front
Panel INPUT/Trim Control to select the desired Trim
Function and then rotate the VOLUME/Adjust Con-
trol to vary or make changes. Refer to figure 50. The
Remote Control TRIM and LEVEL UP and LEVEL
DOWN Push-buttons may also be used. Approxi-
mately 5 seconds after Trim Function Selection and/or
adjustments have stopped, the MAC7200 will switch
off the Trim Mode.
Mute
Press the MUTE Push-button to Mute the Audio in
Output 1 (Loudspeakers), Output 2 and Headphones.
The audio signals present at the FIXED OUTPUT
Jacks are not effected by activating the mute func-
tion. The Front Panel Display will indicate the Source
Name and with the word MUTE in place of the actual
volume setting. Refer to figure 97.
Pressing the Mute Push-button a second time
or adjusting the volume control will un-mute the
MAC7200.
After approximately 5 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
HEADPHONE HXD
When headphones are connected to the MAC7200
Front Panel Jack, an additional TRIM function be-
comes available. McIntosh’s HXD brings the acousti-
cal depth and spatiality of music normally heard with
loudspeakers, to your headphones. The default setting
is HXD On. To switch HXD Off perform the follow-
ing:
1. Momentarily press the INPUT Control, then rotate
it to select “HEADPHONE HXD, On”. Refer to
figure 95.
2. To deactivate the HXD Mode rotate the VOL-
UME Adjust Control until the Front Panel Display
indicates “HEADPHONE HXD, Off”. Refer to
figure 96.
METER BACKLIGHT
The MAC7200 Front Panel Meter Illumination may be
switched On or Off by performing the following:
1. Select “METER LIGHTS, On” as indicated on the
Front Panel Information Display. Refer to figures
70, 73 (on page 28) and 91.
2. Switch Off the Meter Illumination. Refer to
figure 92.
After approximately 5 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
Notes: 1. Meter Illumination of recent McIntosh Power
Amplifiers will also switch On/Off when con-
nected to the MAC7200 via a power control
cable.
2. Some A/V Processors will provide an On/Off
Control Signal when the MAC7200 Passthru
Input Jack is connected to the A/V Processor
via the power control cable.
INFORMATION DISPLAY ILLUMINATION
The Brightness Level of the MAC7200 Front Panel
Information Display can be adjusted from bright to
dim by performing the following:
1. Select “DISPLAY BRIGHTNESS” as indicated
on the Front Panel Information Display. Refer to
figures 70, 73 (on page 28) and 93.
2. Reduce the Brightness level by adjusting the
TRIM LEVEL. Refer to figure 94.
How to Operate the MAC7200, con’t
Figure 91
METER LIGHTS
On
Figure 92
METER LIGHTS
Off
Figure 94
DISPLAY
BRIGHTNESS
Figure 93
DISPLAY
BRIGHTNESS
Figure 96
HEADPHONES HXD
Off
Figure 95
HEADPHONES HXD
On
Figure 97
COAX 1
MUTE
48kHz
Loading ...
Loading ...
Loading ...