Loading ...
Loading ...
Loading ...
ENGLISH
7
TroubleshootingInformationHDMI Control FunctionPlaybackSetupConnections Specications
Inserting the Batteries
About the Remote Control
e Put the rear cover back on.
q Remove the rear cover. w Set three R6/AA batteries in
the battery compartment in the
indicated direction.
NOTE
• Use R6/AA batteries in this remote control.
• Replace the batteries with new ones if the set does not operate
even when the remote control is operated close to the unit. (The
supplied batteries are only for verifying operation.)
• Be sure to insert the batteries in the proper direction, following the
“q” and “w” marks in the battery compartment.
• To prevent damage or leakage of battery uid:
Do not use a new battery with an old one.
Do not use two different types of batteries.
Do not attempt to charge dry batteries.
Do not short-circuit, disassemble, heat or dispose of batteries
in a re.
• If the battery uid leaks, carefully wipe the uid off the inside of the
battery compartment and insert new batteries.
• Remove the batteries from the remote control if it will not be used
for a long time.
• Used batteries should be disposed of in accordance with local
regulations on battery disposal.
Operating Range of the Remote Control
Operate the remote control while pointing it at the remote sensor.
30°
30°
Approx.23feet/7m
NOTE
The set may function improperly or the remote control may not
operate if the remote control sensor is exposed to direct sunlight,
strong articial light from an inverter type uorescent lamp or infrared
light.
Remote Control Settings (Remote
Control Side)
Switches when the DBP-A100’s remote control operates another
DENON BD players in the vicinity.
Set the remote control code simultaneously on the main unit, too.
For instructions on setting codes, see GUI menu: “Other Setup” –
“Remote Control Setting” – “Remote ID” (vpage 31).
GRemote control code settingH
1
: Set the remote control code to “1”.
2
: Set the remote control code to “2”.
• If the signal code of the remote control does not match the signal
code of the unit, the remote control code set on the unit is shown
on the display.
GExampleH
If the code setting on the unit is “DENON 1”, and the setting on the
remote control is “2”, “PLAYER 1” is shown on the display.
NOTE
• Match the signal code of the remote control with the signal code of
the unit. If the remote control code is different, you cannot operate
the DBP-A100 with the remote control.
• Even if you change the remote control code, set the GUI menu
“Other Setup” – “Remote Control setting” – “Receive Legacy
Remocon” (vpage 31) to “Off” when operating the DBP-A100
with a remote control other than DENON’s.
Getting Started
1.DBP-A100_E3_ENG_007.indd 7 2010/08/12 19:20:06
Loading ...
Loading ...
Loading ...