Loading ...
Loading ...
Loading ...
If and when368
To change the bulb
Assembling the tail light units
Complete operations only in the sequence given:
5.
Unscrew the attachment screw page 367, fig. 221 using the
screwdriver from the on-board tools page 353. The bolt is
secured in its position.
6.
Extract the tail light from the bodywork by carefully pulling back-
wards.
7. Pull the red strip on the connector and extract the connector.
8. Disassemble the tail light unit and place it on a flat, clean surface.
9.
To release the lamp holder, press on the attachment tabs
page 367, fig. 222 to in the direction of the arrow.
10. Remove the lamp holder from the tail light unit.
11. Replace the faulty bulb by a new identical bulb.
12.
Place the lamp holder in the tail light unit. The attachment tabs
should audibly click into place.
13.
Insert the connector and press the red attachment strip in so that
the connector is locked into place.
Rear light, left Rear light, right
A
2
A
1
A
4
Rear light, left Rear light, right
14.
Carefully insert the tail light unit into the opening in the bodywork.
To do this, insert the upper tail light unit guide into the attachment
ring.
15.
Tighten the white attachment screw using the screwdriver from the
on-board tools.
16.
Ensure that the tail light unit has been correctly fitted and is firmly
secured.
17.
Replace the cap and rotate it
90° in the opposite direction of
the arrow.
Move the 12 V socket support
upwards gently until it is correctly
closed.
18. Close the storage compartment.
19. Close the tailgate page 97.
A
1
Loading ...
Loading ...
Loading ...