Loading ...
Loading ...
Loading ...
Unlocking and locking 111
Safety First Operating instructions Practical tips Technical Data
x Search the manufacturer's instructions manual for the garage door or
gate to find the “setting button” for the power motor to synchronise a new
remote control.
x After pressing the “settings button” on the power motor, you have a
maximum of 30 seconds to press the button , or . Press the same
button once more to complete the process. For some systems, the button
must be pressed the third time.
Erasing the programming for all buttons
SEAT recommends erasing the programming for all buttons when selling or
loaning your vehicle.
x Before programming, carry out the initial steps page 110.
x Press the buttons and until the indicator above the button begins
to blink.
x Release both buttons. All of the programmed functions are erased.
After programming
Check the garage door remote control page 111, “Using the garage door
remote control”.
Using the garage door remote control
The vehicle must be within range of the garage door or gate power motor.
x With the engine running or the ignition on, push the corresponding
button on the sunshade .
WARNING
Careless use of the garage remote control can cause serious injury.
x Only use the remote control when you can see the garage door and that
there is nobody in its way.
Caution
Use of inappropriate batteries may damage the remote control. For this
reason, always replace the dead battery with another of the same voltage,
size and specifications.
For the sake of the environment
Please dispose of your used batteries correctly and with the utmost respect
for the environment.
1 2 3
1 3 2
Fault Possible cause Possible solution
Garage door or
electric system is
not working.
The batteries of
remote control are
flat.
Change the batteries.
The remote control is
too far away or the
transmission angle
was to large.
Vary the distance and the angle
to the receiver.
The garage door or
electric system are
not compatible.
The system does not corre-
spond to legal requirements
and must be replaced.
Programming was
not completed cor-
rectly.
Program the remote control
once more.
Loading ...
Loading ...
Loading ...