Loading ...
Loading ...
Loading ...
63
- Motor brake: Brake on (brake coil turned o) (User press enter to
turn brake o)
- Step sensors
Test
Use sensor outputs to light DM similar to Symmetry display. This
test is only to make sure the sensors are functioning and does
not test accuracy. The DM graph shows left and right sensor
activity when stepping on the deck. Both sides of the graph will
light at the same time, but the side the user steps with would
show more segments lit.
Calibration
- MW: START LEFT SIDE
- When Start is pressed the MW shows: AD _ _ _ TGT 65
- Speaker will beep slowly when magnet distance is too far,
quickly when near and steady when correct.
- Press enter to continue
- MW: START RIGHT SIDE
- When Start is pressed the MW shows: AD _ _ _ TGT 65
- Speaker will beep slowly when magnet distance is too far,
quickly when near and steady when correct.
- User press enter or stop to end calibration
• Acceleration key lock
- MW show “accel key”, press enter then MW shows “accel
locked”. This is the default. If the user presses the up or down key
the MW shows “accel unlocked”. Press enter to exit.
• Speed limit setting
- MW shows “speed limit”, press enter. The MW shows limit 10.0
mph. This is the default setting and is the top forward speed of the
treadmill.
- If the user presses the down key the MW shows Limit 9.9 mph.
The top limit can be changed in 0.1 mph increments.
- The minimum speed limit setting is 3.0 mph.
• Security
- MW show “security” MW shows “child lock on ” or o , Sets
the child lock function. This function locks out the keypad until a
pre-determined key sequence is pressed. Key sequence = start &
enter held down together until unlocked.
1
2
Loading ...
Loading ...
Loading ...