Loading ...
Loading ...
Loading ...
20
Adjusting the hand rail vertical position
• To lift: Turn both the left and right vertical adjustment knobs
counterclockwise one or two rotations. Then just grab the lift bar
and pull up. The locking pins in the knobs will automatically ratchet
into the indexing holes in the tubes. Tighten the knobs when
desired position is set. There is a numbered scale on the tubes for
repeatable settings.
• To lower: Loosen the two knobs and then pull them out and rotate
slightly until the knob remains out on its own. The pin should now
be disengaged from the tube and you can use the lift bar to lower
the rails. Lower the rail past the position you desire and rotate the
knob again so the pin can engage the holes in the tube. Now lift the
rails to the desired position and lock the knob.
Adjusting the hand rail horizontal position
Turn both the left and right levers counterclockwise one rotation.
Move the rails to the desired position and re-lock the levers. There
are numbered scales on the tubes for repeatable settings. The levers
may be blocked by the rotating tube when position is changed. The
levers can be repositioned by pulling out and rotating them to a new
position, allowing tightening.
Lift bar
The lift bar will make raising and lowering the hand rails easier. You
can remove the lift bars for better patient access by loosening the
locking knobs. Hold the bar with one hand and loosen the knobs with
the other so the lift bar does not suddenly fall to the oor.
Rear step
Additional step lowers the step-up height to 4 inches. To install or
remove the step easily there are two removable pins located under
the rear of the treadmill. Be sure these two pins are in place before
using.
Loading ...
Loading ...
Loading ...