Loading ...
Loading ...
Loading ...
UF V (E3) 10/2020 Page 91/119
24.2 Decontamination
The operator must ensure that proper decontamination is performed in case a contamination of the cham-
ber by hazardous substances has occurred.
Disconnect the chamber from the power supply prior to chemical decontamination. Disconnect the power
plug.
Do not use decontamination agents that may cause a hazard due to reaction with components of the device
or the charging material. If there is doubt regarding the suitability of cleaning products, please contact
BINDER service.
You can use the following disinfectants:
For chemical disinfection, we recommend using the disinfectant spray Art. No. 1002-0022.
Any corrosive damage that may arise following use of other disinfectants is excluded from lia-
bility by BINDER GmbH.
With every decontamination method, always use adequate personal safety controls.
In case of eye contact, the disinfectant spray may cause eye damage due to chemical
burns. Follow the operating instructions and safety hints labeled on the bottle of the disin-
fectant spray.
Recommended precautions: To protect the eyes use sealed protective goggles.
CAUTION
Danger of chemical burns through eye contact with the disinfectant
spray.
Eye damage. Environmental damage.
∅ Do NOT empty the disinfectant spray into drains.
Wear protective goggles.
After using the disinfectant spray, allow the chamber to dry thoroughly, and aerate it suffi-
ciently.
Alternatively, you can use the following disinfectants (apply on a cloth):
Interior (stainless steel)
Standard commercial surface disinfectants free from acid or halides
(not dripping).
Alcohol based solutions.
Compartment doors
Standard commercial surface disinfectants free from acid or halides
(not dripping).
Alcohol based solutions max. 10%
Outer door gasket (PVC) and in-
ner door gasket (silicon)
Alcohol based solutions
Following use, completely remove any disinfectant with a sterile moistened towel from the
surfaces.
Before start-up, the chamber must be absolutely dry and ventilated, as explosive gases may form during
the decontamination process.
Loading ...
Loading ...
Loading ...