Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Machine Power cord not plugged in. Plug in power cord.
Stops No power at plug. Check electrical source or call
electrician.
Fuse blown or circuit Replace fuse or reset circuit breaker.
breaker open. If problem continues, call electrician.
Using an extension cord. Do not use extension cords.
Washer at pause in Allow cycle to continue
PERMANENT PRESS Cycle (see "Operating Your Washer").
(approximately two minutes).
Machine is overioaded. Wash smaller ioads.
Water Level The top of the agitator is much This is normal.
Too Low/Not higher than the highest water
Completely level. This creates a perception
Filling of the washer not being full.
Tub is Tub pulled forward when Ensure tub is centered before
Crooked unloading, starting washer.
Tub moves. Tub drops This is normal.
during fill.
Unit not level. Ensure front feet are installed,
Level washer (see "Permanent
Installation Instructions").
Lint on Load Improper sorting. Sort lint givers from lint takers
and by color,
Overloading. Lint can be trapped in load if
overioaded. Wash smaller ioads.
Paper or tissue in pockets. Clean out pockets before washing.
Not enough detergent, Use enough detergent to
hoid lint in water.
Detergent not dissolving. Water Use wash water warmer than 70°F
temperature below 70°F (21°C). (21° C).
35
Loading ...
Loading ...
Loading ...