Loading ...
Loading ...
Loading ...
CONNECT FILL-AND-DRAIN
HOSE TO WASHER
Proper connection of the fill-and-drain
hose will protect your floors from
damage due to water leakage.
STEP 1. Attach the fill-and-drain hose
to the cold water (top) inlet valve. Tighten
coupling by hand. Use pliers to make an
additional two-thirds turn. DO NOT
OVERTIGHTEN; this could damage the
coupling. The hot water (bottom) inlet
valve is capped. Leave this valve capped.
IMPORTANT: To ensure proper
installation, this procedure must be
followed exactly.
a. Wet the inside end of the fill-and-drain
hose with tap water. DO NOT USE
ANY OTHER LUBRICANT.
b. Squeeze ears of silver, double-wire
clamp with pliers to open. Place
clamp over the straight end of the
fill-and-drain hose 1/4 in (0.64 cm) from
the end.
c. Open clamp. Twist hose back and
forth while pushing down onto drain
connector at the bottom of the washer.
Continue until hose contacts the
cabinet.
TWIST
AND
PUSH
STEP 2. To prevent the fill-and-drain
hose from coming off or leaking, it
must be installed per the following
instructions:
I/4 in Fill-and-Drain
(0.64 cm)
Hose \_
!Clamp
__1/4 in
f_- Housing _ _4 cm)
d. Release clamp.
I0
Loading ...
Loading ...
Loading ...