Loading ...
Loading ...
Loading ...
LAUNDRY TUB DRAIN SYSTEM
Check location where washer will be
installed. This washer can be installed
using one of three systems:
• Laundry tub drain system (below)
• Standpipe drain system (p. 13)
• Floor drain system (p. 13)
Do not store or operate washer at or
below 32°F (0°C) (some water may
remain in washer). See page 32 for
Winterizing Information.
Proper installation is your responsibility.
Make sure you have everything
necessary for correct installation including
the following points:
Grounded receptacle: Must
be within 5 ft (1.5 m) of where
the power cord is attached to
the back of the washer.
Washer must
be level
(see pp. !5 ............................
and 19).
Support: Floor must be sturdy
enough to support a total weight
of 260 Ib (118 kg) (washer,
water and load weight).
I2
Hot and cold water faucets:
Must provide water pressure
between 5-!00 psi and be
within 31/2ft (1.1 m) of the hot
and cold water fill valves
attached to the back of the
washer.
J
Level floor: Maximum
allowable slope under
entire washer- 1 in
(2.5 cm).
a sink or laundry tub with a
carry-away capacity of 13 gal
(49.2 L) per minute. The top of
the tub must be at least 39 in
(99 cm) above floor and no
higher than 72 in (183 cm) from
bottom of washer.
Loading ...
Loading ...
Loading ...