Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Continues Drain hose is less than Raise the drain hose
to Fill/ 39 in (99 cm) above floor (see instructions for portable or
Continues (27 in [68.9] for portable washers), permanent installation).
to Drain/ Drain hose fits tightly into Adjust drain hose for loose fit
Cycle Stuck standpipe. (see "Permanent Installation
Instructions").
Drain hose taped into Do not seal off drain hose with tape.
standpipe. The drain hose needs an air gap.
Washer Load is unbalanced. Redistribute toad.
Makes Noise
Washer is not levet. Level washer (see "Permanent
Installation Instructions").
Ftoor not strong enough Relocate washer
to support washer. (see "Permanent Installation
Instructions").
Gears engaging after wash This is normal.
and before drain.
Won't Water inlet valve Ciean screens.
Fill/Won't screens are piugged.
Rinse/Won't Water is turned off. Turn on water,
Agitate/
Wrong Hot and cold hoses are Reverse hoses
Temperature reversed. (see "Permanent Installation
Instructions").
inlet hose is kinked. Straighten hoses.
Cycle Selector Control knob Turn knob to the right slightly and
is not lined up. push the START/PAUSE button.
Power cord not piugged in. Plug in power cord.
Temperature selection is Select WARM/WARM for portabie
wrong for portable installation, installations (see "Operating Your
Washer-Portable Only").
34
Loading ...
Loading ...
Loading ...