Loading ...
Loading ...
Loading ...
ATTACH FAUCET ADAPTER KIT REVIEW INSTALLATION
Proper connection of your faucet
adapter kit will allow hot and cold
water to enter your washer properly.
It also helps prevent water damage
due to leaks.
STEP 1. With washer lid closed, roll
washer to sink area. It rolls and operates
on casters. Be sure your washer is on a
level floor to avoid movement during spin.
STEP 2. Attach the faucet adapter
kit from the parts bag to your faucet.
A standard faucet adapter and washer
are supplied. Customized adapters
are available from traditional plumbing
supply sources.
_l_,Jil,m_i "-I:.Ii[9 i_ "
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation and
increase your satisfaction with your
Kenmore washer.
[] Check electrical requirements.
Be sure you have correct electrical
supply and recommended grounding
method.
[] Check that you have:
• All the tools you started with.
• Removed all shipping and
packaging materials.
• Installed all parts listed on page 9. ...................
_ Washer
_ Adapter
FINAL STEPS
[]
[]
[]
BEFORE YOU START your washer,
attach fill-and-drain hose connector
to a single-spout, hot-cold water faucet
by moving locking collar down while
lifting the connector until it snaps into
place (see page 20).
Plug into a grounded 3 prong outlet.
Take a few minutes and read the
"OPERATING YOUR WASHER"
section to fully understand your new
washer. Then, start the washer and
allow it to complete the REGULAR
Cycle.
NOTE: If the washer is attached to
a faucet equipped with a spray hose,
the constant water pressure may cause
the spray hose to leak. To prevent
possible failure, the spray hose should
be disconnected or replaced with a
high-pressure hose.
11
Loading ...
Loading ...
Loading ...